Filter
Top Products
T r o u b l e s h o o t i n g
LifeBook 900 Series from Fujitsu
149
5. Setup utility is set to something other 5. Revise BIOS settings to set the Secondary
than CD-ROM for the Secondary Master correctly. (See Main menu and
Master Controller. Secondary Master submenu pages 60–61
for more information.)
6. Wrong drive designator was used for 6. Verify the drive designator used by the
CD-ROM in the application. application is the same as the one used by
the operating system. When the operating
system is booted from a CD-ROM drive
designations are automatically adjusted.
(See Boot Options submenu on page 106.)
7. Windows CD auto insertion function 7. Start the CD from the desktop or applica-
is disabled. tion software or re-enable the Windows CD
auto insertion function. (See CD-ROM
Drive Access Indicator on pages 21–22 for
more information.)
The CD-ROM Access indicator on the Status 1. The Windows CD auto insertion function 1. This is normal. You can disable this
Indicator panel blinks at regular intervals when is active and is checking to see if a CD function if you wish. (See CD-ROM Drive
no CD is in the tray or the CD-ROM drive is is ready to run. Access Indicator on pages 21–22 for
not installed. more information.)
Symptom Possible Cause Possible Solution