Filter
Top Products
BEFOREYOU BEGIN
Read these instructions completelyand carefu~y.
WORT~ Savethese instructions for the
lod electricrdinspectors use.
~PORT~ OBSERVE ~ GOVE-G
CODES ~ ORDIN~C~.
N~ ~ ~ST-R have these instructions
with the appfianceafter initiation is completed.
N~ TO CONSUMER Keep tils Use and
Care Guide and Ins~ation Instructions for
future use.
N~. This apptiancemust be properlygrounded.
TOOLSYOU WILL NEED
. kge
bladescrewdriver
● Channellockpfiersor smallratchetwrench
(forlevehg range)
● l/4inch hex headnutdriver
ELECTRIU REQUIREMENTS
W~ON—POR PERSON~ ~
DO NOT USE ~ -NSION CORD
= ~S ~P~CE.
This apptice must be supptiedwith the proper
voltage and frequency, and connected to an
individud, properly grounded branch circuit
protected by a circuit breaker or time delayfuse,
as noted on the rating plate.
Wtig must conformto Natioti Electrid Codes.
Hthe electric service provided does not meet the
above spectications, it is recommended that a
ticensed electrician insti an approved outiet
Because the range terminals are not accessible
after the range is in position, a flexibleservice
conduit or cord must be used.
Step 1
CHOOSEM lNSTMMT!OHLOUTIOW
Choosea ltim based on the foU* *H:
1. The range is designed to be vented outdoors.
2. The electrid rating is 14.7~, 120/240V,
60 W.
3. Drafts caused by home heating and ~
conditioningand or open doors or windows can
disrupt the ventilationair pattern. The range
should not be instied near windows or doors.
4. The unit cannot be instied in a tunnel type
WWopening.M currents movingthrough the
tunnel m disrupt the ventilationair pattern.
5. The range can either be ducted through the
wd or through the floorto the outside.
6. Make sure there is adequate space for proper
initiation.
7. Removeprotective packing materials from the
range. Tape residue can be cleaned with a soft
cloth and alcohol.
8. Carefu~yread d instructions before
beginning initiation.
(continuednti)age)
47