Filter
Top Products
– 29 –
To replace the door:
Firmly grasp both sides of the door at the top.1.
With the door at the same angle as the removal 2.
position, seat the indentation of the hinge arm
into the bottom edge of the hinge slot. The
notch in the hinge arm must be fully seated into
the bottom of the slot.
7. On both sides of the door, press down on the
release buttons on each hinge.
8. Lift the door up until it is clear of the hinge.
Door
Frame
Release buttons
Indentation
Bottom
edge
of slot
Hinge arm
3. Fully open the door. If the door will not fully
open, the indentation is not seated correctly in
the bottom edge of the slot.
4. Push the hinge locks up against the front frame
of the oven to the locked position.
Hinge
lock
Hinge
arm
5. Close the oven door.
Remove the two T15 Torx screws (1 on each 4.
side) from the outer door assembly.
Caution: Care must be taken if reinstalling the door
handle. Overtightening the screws can damage the
handle. Hand-tighten the screws and make sure the
handle fits snugly against the door panel. (Do not
use an electric driver.)
To remove the lower outer door assembly:
Remove the lower door. (See 1.
Door Assemblies.)
Place the inner door assembly, gasket side up, 2.
on a protective surface.
Remove the four T15 Torx screws from the 3.
bottom of the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
Separate the inner door assembly from the 5.
outer door assembly.
Remove the four 1/4-in. hex-head screws and 6.
brackets that hold the door handle to the outer
door assembly.
Door Shown with Inner Door Assembly Removed
Outer Door Assembly
1 of 2
(Continued next page)