Filter
Top Products
– 37 –
Convection Bake Element
The inner convection element is rated at 655 watts
and the outer convection element is rated at 645
watts.
The convection bake element is located on the back
wall of the oven.
To remove the convection bake element:
Remove the oven. (See 1.
Oven Removal.)
Remove the main rear access panel. (See 2.
Rear
Access Panels.)
IMPORTANT: The lower wattage elements use
3/16-in. terminal connections. The higher wattage
elements use 1/4-in. terminal connections.
3. Disconnect the wires from the convection bake
element.
7. Carefully pull the convection bake element
toward the front of the oven.
Convection Fan Motor
The convection fan motor is located on the back
wall of the oven cavity.
The convection fan will turn on (after a short delay).
The fan may cycle on and off, and change direction,
to best distribute hot air in the oven. The convection
fan shuts off when the door is opened.
The convection fan motor has approximate
resistance values between the following wires:
• Red and Blue: 168 Ω
• Red and Gray: 75 Ω
• Blue and Gray: 93 Ω
To remove the convection fan motor assembly:
Remove convection fan blade. (See 1.
Convection
Fan Blade
.)
Remove the rear access panel. (See 2. Rear Access
Panels.)
Disconnect the convection fan motor wire 3.
harness.
Remove the three 1/4-in. hex-head screws that 4.
hold the convection fan motor to the back of the
oven.
Disconnect
4. Remove the oven racks.
5. Remove the four 1/4-in. hex-head screws that
hold the convection cover to the back wall of the
oven cavity. (See
Convection Fan Blade.)
6. Remove the five 1/4-in. hex-head screws that
hold the convection bake element to the back
wall of the oven cavity.