Filter
Top Products
– 35 –
Oven Temperature Sensor
The resistance of the temperature sensor is:
1080 • Ω at room temperature
2650 • Ω at clean temperature
To remove the oven temperature sensor:
Remove the main rear access panel. (See 1.
Rear
Access Panels.)
Remove the two 1/4-in. hex-head screws that 2.
attach the sensor to the broiler element bracket.
Disconnect the sensor wiring harness from the 3.
back of the oven.
5. Remove the thirteen 1/4-in. hex-head screws
from the top of the heat shield.
1 of 13
6. Lift up the top heat shield.
Disconnect
(Continued next page)
Broil Element
The broil element will not work if the temperature
probe is plugged in. The broil element terminals are
located behind the main rear access panel.
The broil elements are rated at:
Upper oven broil element (inner) - 1700 watts•
Upper oven broil element (outer) - 1050 watts•
Lower oven broil element (inner) - 2200 watts•
Lower oven broil element (outer) - 750 watts•
To remove the broil element:
Remove the main rear access panel. (See 1.
Rear
Access Panels.)
4. Carefully pull the sensor and sensor wiring
harness from the oven liner.
Note: When reinstalling the sensor, use a small flat-
bladed screwdriver to push and guide the sensor
wire harness into the oven liner.
IMPORTANT: The lower wattage elements use
3/16-in. terminal connections. The higher wattage
elements use 1/4-in. terminal connections.
2. Disconnect the wires from the broil element.
Disconnect
Disconnect
Disconnect
Disconnect
3. Remove the two 1/4-in. hex-head screws that
attach the temperature sensor to the broiler
element bracket.