Filter
Top Products
– 30 –
To replace the lower inner door assembly:
Remove the outer door assembly. (See 1.
Door
Assemblies.)
2. Remove the four T15 Torx screws (2 on each
side) that attach each door hinge to the inner
door. Carefully turn the door over and remove
both door hinges.
(Continued next page)
3. Remove the six 1/4-in. hex-head screws that
hold the insulation retainer to the inner door.
Remove the insulation retainer.
4. Remove the insulation and the inner glass
assembly from the inner door.
Inner Glass Assembly
To remove the upper outer door assembly:
Remove the upper door. (See 1.
Door Assemblies.)
Place the inner door assembly, gasket side up, 2.
on a protective surface.
Remove the two T15 Torx screws from the 3.
bottom of the outer door assembly.
Remove the two T15 Torx screws (1 on each 4.
side) from the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
Separate the inner door assembly from the 5.
outer door assembly.
Remove the four 1/4-in. hex-head screws and 6.
brackets that hold the door handle to the outer
door assembly.
Door Shown with Inner Door Assembly Removed
Outer Door Assembly
Caution: Care must be taken if reinstalling the door
handle. Overtightening the screws can damage the
handle. Hand-tighten the screws and make sure the
handle fits snugly to the door panel. (Do not use an
electric driver.)
1 of 2