Filter
Top Products
– 55 –
Problem Possible Causes What To Do
"Crackling" or
"popping" sound
This is the sound of
the metal heating and
cooling during both the
cooking and cleaning
functions
This is normal.
Excessive smoking
during a clean
cycle
Excessive soil
Touch the CLEAR/OFF pad. Open the windows to rid the
room of smoke. Wait until "LOCKED" goes off. Wipe up the
excess soil, and reset the clean cycle.
Oven door will not
open after a clean
cycle
Oven too hot Allow the oven to cool below locking temperature.
Oven not clean
after a clean cycle
Oven controls not
properly set
See the Using the Self-Cleaning Upper and Lower Ovens
section.
Oven was heavily
soiled
Clean up heavy spill-overs before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for a
longer period of time.
"LOCKED" flashes
in the display
The self-clean cycle
has been selected, but
the door is not closed
Close the oven door.
"LOCKED" is on
when you want to
cook
The oven door is
locked because the
temperature inside the
oven has not dropped
below the locking
temperature
Touch the CLEAR/OFF pad. Allow the oven to cool.
"F - and a number
or letter" flash in
the display
There is a function error
code
Disconnect all power to the oven for at least 30 seconds,
and then reconnect power. If the function error code
repeats, call for service.
"LOCKED" appears
in the oven display
The controls have been
locked
See the Using the Clock, Kitchen Timer, and Control Lock
section to unlock.
Control signals
after entering
cooking time or
start time
You forgot to enter a
bake temperature or
cleaning time
Touch the BAKE pad and desired temperature or the SELF
CLEAN HI/LO pad and desired clean time.
Display goes blank
A fuse in the home may
be blown or the circuit
breaker tripped
Replace the fuse or reset the circuit breaker.
The clock is in the
black-out mode
See the Special Features of the Oven Control section.
Display flashes Power failure Reset the clock.
Unable to get the
display to show
"SF"
Oven control pads were
not touched properly
The BROIL HI/LO pad and the BAKE pad must be touched
at the same time and held for 3 seconds.
"Probe" appears in
the display
This is reminding
you to enter a probe
temperature after
plugging in the probe
Enter a probe temperature.
(Continued Next Page)