Filter
Top Products
ode
-8.
ELS)
PRIMARY CONTACTOR
30 31 32
Each electric fryer requires two switching contactors. One is
the primary contactor and the second in line is the heat con-
tactor. When open, the primary contactor allows no power to
flow to the heat contactor. When closed, the primary eontac-
tor completes the timer circuit and the high limit (heat) cir-
cuit. It also supplies power to the heat contactor which is con-
trolled by the thermostat.
1. Remove electrical power supplied to the cookpot to be work-
ed on.
Place POWER switch to the OFF position, and unplug
the power cord or open the wall circuit breaker, or elec-
trical shock could result. Be aware that the other con-
trols will have power.
2. Remove the control panel and insert it in the slot above the
door. Refer to section 6-3.
3. Perform a check on the contactor as follows:
Test Points
Results
from 23 to 29
from 24 to 28
from 25 to 27
from 30 to 34
from 31 to 35
from 32 to 36
from 22 to 26
from 33 to 37
open circuit
open circuit
open circuit
open circuit
open circuit
open circuit
ohm reading 415
ohm reading 1500
Wires should be removed and labeled to obtain an accurate
check of contactors.
I