Filter
Top Products
The Power Switch is a two way rocker switch. With the switch
in the “ON” position, this energizes the controls.
1. Remove power supplied to the unit, or on electric models,
to the cookpot to be worked on.
Disconnect power supplied to the unit by unplugging
the power cord, or turning off the wall circuit breaker
or fuse. Be aware that the other controls will have
power on electric models, or electrical shock could
result.
2. Remove appropriate control panel, but leave hinged on unit.
3. Remove and label wires from the switch and check across
top and bottom terminals for continuity. With the switch
in the “ON” position, the circuit should be closed. If the
switch is defective, replace it by following the next steps.
4. Push in on tabs on the ends of the switch and pull switch
from the front of the control panel.
5. Replace new switch, replace wires, and replace control
panel.
6. Reapply power to unit.