Filter
Top Products
33
Models C708 & C716 Operating Procedures
USE EXTREME CAUTION when handling
the beater assembly. The scraper blades are very
sharp and may c ause i njury.
Step 6
Before installing the beater assembly, check the
scraper blades for any nicks or signs of wear . If any
nicks are present, or if the blades are worn, replace
both blades.
If the b lades are in good condition, install the
scraper blade clips over the scraper blades. Place
the rear scraper blade over the r ear holding pin on
the beater. (See Figure 14.)
Figure 1 4
Note: Scraper blades should be replaced every 3
months.
Note: The hole o n t he scraper blade must fit
securely over the p in to prevent costly damage.
Step 7
Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin. (See Figure 15.)
Figure 1 5
Step 8
Install the beater shoes. (See Figure 16.)
Figure 1 6
Step 9
Slide the beater assembly the rest of the way i nto
the freezing cylinder.
Make sure the beater assembly is in position over
the drive shaft by turning the beater slightly until the
beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder. (See Figure 17.)
Figure 1 7
Repeat these steps for the other side of the
Model C716.