Filter
Top Products
42
Models C708 & C716Operating Procedures
120209
Step 13
Place the agitator on the agitator drive shaft
housing. (See Figure 47.)
Figure 4 7
Note: If agitator should stop turning during normal
operation, with sanitized hands, remove agitator
from agitator drive shaft housing and brush clean
with sanitizing solution. Install the agitator back onto
the agitator drive shaft housing.
Step 14
Remove the cotter pin from the pump. Remove the
feed tube and pos ition i t a s s hown in the illustration
below. Place the cotter pin in position on the out let
fitting of the pump assembly.
(See Figure 48.)
Figure 4 8
Repeat these steps for the other side of the
Model C716.
Priming
Note: Use only FRESH MIX when priming the
freezer.
Step 1
Place an e mpty mix pail beneath t he door spout(s).
Pour 2-1/2 gallons (9.5 liters) of FRESH mix i nto the
mix hopper and allow it to flow into the freezing
cylinder.
Step 2
Open the draw valve to r emove all sanitizing
solution. When only fresh mix i s flowing, close the
draw valve.
Note: Momentarily open the center draw v alve to
remove sanitizer from the center door spout (C716
only).
Step 3
When mix stops bubbling down into the freezing
cylinder, remove the cotter pin from the outlet fitting
of the mix pump. Insert the outlet end of the mix
feed tube into the mix inlet hole in the mix hopper.
Place the inlet end of the mix feed tube into the
outlet fitting of the m ix pum p. Secure with cotter pin.
Figure 4 9
Step 4
Select the AUTO symbol
.
Step 5
Fill the hopper with fresh mix and place the m ix
hopper cover in pos ition.
Repeat these steps for the other side of the
Model C716.