Filter
Top Products
39
Models C708 & C716 Operating Procedures
120209
Step 9
Secure the pump parts in position b y s liding the
retaining pin through the cross holes located a t one
end of the pum p cylinder. (See Figure 37.)
Figure 3 7
Note: The head of the retaining pin should l ocated
at the top of the pump when installed.
Step 10
Assemble the feed tube as sembly. Slide the check
ring into the g roove of the feed t ube.
(See Figure 38.)
Figure 3 8
Step 11
Install one r ed o-ring on each end of the mix feed
tube, and thoroughly lubricate. (See Figure 39.)
Figure 3 9
Step 12
Lay the pump assembly, pump clip, cotter pin, mix
feed tube assembly, and agitator in the bottom of
the mix hopper for sanitizing. (See Figure 40.)
Figure 4 0