Filter
Top Products
5
Models C708 & C716 Safety
101206
Section 3 Safety
We, at Taylor Company, are concerned about the
safety of the operator when he or she comes in
contact with the freezer and its parts. Taylor has
gone to extreme efforts to design and m anufacture
built-in safety features to protect both you and the
service technician. As an example, warning labels
have been attached to the freezer to further point
out safety precautions to the operator.
IMPORTANT - Failure to adhere to the
following safety precautions may resu lt in
severe personal injury or death. Failure to
comply with these warnings may d amage the
machine and its components. Component
damage will result in part replacement expense
and service repair expense.
DO NOT operate the freezer without
reading this Operator Manual. Failure to follow this
instruction may result in equipment damage, poor
freezer performance, health hazards, or personal
injury.
Per IEC 60335-1 and it s part 2 standards,
“This appliance is to be us ed only by trained
personnel. It is not intended for us e by children or
people with reduced phy sical, sensory, or mental
capabilities, or lack of experience and knowledge,
unless given supervision or instruction concerning
the use of the applianc e by a person responsible for
their safety.”
This unit is provided with an equipotential
grounding lug that is t o be properly attached to the
rear of the frame by the authorized installer. The
installation location is marked by the equipotential
bonding symbol (5021 of IEC 60417- 1) on both the
removable panel and the equipment's frame.
DO NOT use a water jet to clean or r inse
the freezer. Failure to follow these ins tructions may
result in serious electrical shock.
S DO NOT operate the freezer unless it is
properly grounded.
S DO NOT operate the freezer with larger
fuses than specified on the freezer data
label.
S All repairs must be performed by an
authorized Taylor service technician.
S The main power s upplies to t he machine
must be disconnected prior to per forming
any repairs.
S Cord Connected Units: Only Taylor
authorized service technicians may install a
plug on this unit.
S Stationary appliances which are not
equipped with a power cord and a plug or
another device to disconnect the appliance
from the power source must have an all- pole
disconnecting device with a contact gap of
at least 3 mm ins talled in the external
installation.
S Appliances that are permanently connected
to fixed wiring and for which leakage
currents may exceed 10 m A, particularly
when disconnected or not used for long
periods, or during initial installation, shall
have protective devices such as a GFI, to
protect against the leakage of current,
installed by the authorized personnel to the
local codes.
S Supply cords used with this unit shall be
oil-resistant, sheathed flexible cable not
lighter than ordinary polychloroprene or
other equivalent synthetic
elastomer-sheathed cord (Code designation
60245 IEC 57) ins talled with the pr oper c ord
anchorage to relieve conductors from strain,
including twisting, at the terminals and
protect the insulation of the conductors from
abrasion.
Failure to follow these ins tructions may result in
electrocution. Contact your local authorized Taylor
Distributor for service.