Filter
Top Products
1
Models C708 & C716 To the Installer
081208
Section 1 To the Installer
The following are general installation instructions.
For complete installation details, please see the
checkout card.
Installer Safety
In all areas of t he wor ld, equipment should
be installed in accordance with ex isting local codes.
Please contact your local authorities if you have any
questions.
Care should be taken to ensure that all bas ic safety
practices are followed during the installation and
servicing activities related to the installation and
service of Taylor equipment.
S Only authorized Taylor service personnel
should perform installation and repairs on
the equipment.
S Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area f or the
industry standards on lockout/tagout
procedures before beginning any installation
or repairs.
S Authorized service personnel must ensure
that the proper PPE is available and worn
when required during installation and
service.
S Authorized service personnel must remove
all metal jewelry, rings, and watches before
working on electrical equipment.
The main power s upply(s) to the freezer
must be disconnected prior to per forming any
repairs. Failure to follow this instruction may result in
personal injury or death from electrical shock or
hazardous moving parts as well as poor
performance or damage to the equipment.
Note:Allrepairsmustbeperformedbyan
authorized Taylor Service Technician.
This unit has many sharp edges t hat can
cause severe injuries.
Site Preparation
Review the area wher e t he unit will be installed
before uncrating the unit. Make sure that all pos sible
hazards to the user and the equipment have been
addressed.
For Indoor Use Only: This unit is designed to
operate i ndoors, under normal ambient
temperatures of 70_-75_F(21_-24_C). The freezer
has successfully performed in high ambient
temperatures of 104_(40_C) at reduced capacities.
This unit must NOT beinstalledinanarea
where a water jet or hose can be us ed. NEVER us e
a water jet or hose to r inse or clean the unit. Failure
to follow this instruction may result in electrocution.
This unit must be installed on a level surface
to avoid the hazard of tipping. Extreme care should
be taken in moving this equipment for any reason.
Two or more persons are r equired to s afely move
this unit. Failure to comply may result in per sonal
injury or equipment damage.
Uncrate the unit and inspect it for damage. Report
any damage to y our Taylor Distributor.
This piece of equipment is made in the USA and has
USA sizes of hardware. All metric conversions are
approximate and v ary in size.