Filter
Top Products
D
IAGNOSING AN ISSUE
NOTE: Adjustments can be made only in
F
ahrenheit. (5ºF equals approximately 2.8ºC.)
NOTE: At 20°F, pressing the “OFFSET” Soft Key
rolls the Temperature Offset back to 0°F.
3. Press “ENTER” to confirm.
4. When finished, press the “BACK/STOP” Key to
exit the
Test Mode Menu.
Checking Heaters A and B (Figures 30-31)
NOTE: If the Blower Speed is “0”, the Blower will
automatically set to idle air
flo
w at the initiation of
this test.
To turn on Heater A: (Figure 30)
1.
From Screen 1 of the Test Mode Menu, press
the “HEATER A” Soft Key (top right).
2. When finished testing, press the “HEATER A”
Soft Key (top right) to turn Heater A off.
3.
P
r
ess the “
BACK/STOP” Key to end the test
and exit the Test Mode Menu.
To turn on Heater B: (Figure 31, page 26)
1. From Screen 1 of the Test Mode Menu, press
the “HEATER B” Soft Key (middle right).
2. When finished testing, press the “HEATER B”
Soft Key (middle right) to turn Heater B off.
3. Press the “BACK/STOP” Key to end the test
and exit the Test Mode Menu.
LEFT
RIGHT
: A
djusting the Temperature Offset
Step: 1/2
Step: 3Simultaneously press and hold for 1
second to get to the Test Mode Menu
(Screen 1). NOTE: Oven must be in
the Off or Cool-down State.
In this example, the Temperature Offset is
set at 20ºF (approximately 11ºC).
L
EFT
R
IGHT
: Checking Heater A
Step: 1/2
Step: 3Simultaneously press and hold for 1
second to get to the Test Mode Menu
(Screen 1). NOTE: Oven must be in
the Off or Cool-down State.
In this example, Heater A is on.
25