Filter
Top Products
Swing Arm Assembly (Figure 58)
The Swing Arm Assembly is actuated by the Rack
Oscillator Motor. The attached oven rack oscillates
when the Swing Arm Assembly is in motion.
If the rack is not oscillating properly,
1. Ensure “Cool Down” process is completed. (“Cool
Down” message will disappear upon completion.)
2.
Ensure recipe settings have the rack set at “ON.”
(See pages 12-14 for modifying recipes.)
3. If recipe settings are correct, ensure the Rack
Oscillator Motor is working properly (page 41).
4. If problem persists, use the figure below to trou-
bleshoot the Swing Arm Assembly.
5. Unplug the oven.
6. Remove all components from the left and right
sides of the oven (including insulation) to access
the Swing Arm Assemblies.
7. Remove the Swing Arm Covers.
8.
Correct problem and reinstall all components.
NUMBER PART PART NUMBER
86 Drag Link – Swing Arm Assembly HHB-8044
87 Swing Arm Assembly with Link Bar HHB-8050
88 Bushing – Swing Arm Assembly (x2) 100152
89 Swing Arm Assembly HHB-8040
: S
wing Arm Assembly
NOTE: Some oven components have been removed for clarity.
89
88
87
86
56
THE IMPINGEMENT CIRCUIT