Filter
Top Products
Chapter 2 Command Summary
Front Panel to SCPI Command Maps
Programming Guide 2-39
Table 2-2A. HP 53132A (S/N Prefix 3646 and Above) Time Interval
Arming SCPI Command Summary (Continued)
Keyword/Syntax Parameter Form Std/
New
Comments
[:SENSe] (Cont.)
:TINTerval (Cont.)
:ARM (Cont.)
:ESTOP (Cont.)
[:LAYer[1]]
:SOURce
:TIMer
[:STARt]
:SLOPe
:SOURce
:STOP
:SOURce
:TIMer
IMMediate | TIMer |
INTernal2
<numeric_value>
POSitive | NEGative
IMMediate | EXTernal
IMMediate | TIMer
<numeric_value>
New
New
New
New
New
New
New
New
Sets the stop arm delay for Time Interval
measurements.
Sets the time used to delay the stop arm for
Time Interval measurements. Only applies
when [:SENS]:TINT:ARM:ESTOP:SOUR TIM is
selected.
Sets the slope of the external start arm signal
used in external arming Tme Interval
measurements (including Time Interval, Rise
Time, Fall Time, Dutycycle, and Pulse Width).
Only applies when
[:SENS]:TINT:ARM[:STAR]:SOUR EXT is
selected.
Sets the start arm for time interval (including
Time Interval, Rise Time, Fall Time, Dutycycle,
and Pulse Width) measurements.
Subtree.
Sets the stop arm (i.e., the delay) for Time
Interval measurements.
Sets the time used to delay the stop arm for
Time Interval measurements. Only applies
when [:SENS]:TINT:ARM:STOP:SOUR TIM is
selected.