Filter
Top Products
7 - 25 7 - 25
MELSOFT
7 MANAGEMENT OF DATA IN THE PLC CPU
7.4.2 Remote operation
Change the running status of the PLC CPU from GX Explorer.
Note that this operation is enabled in the RUN mode of the PLC CPU.
Click the Remote operation
button in the Delete PLC data dialog box.
1)
3)
5)
2)
4)
No. Item Description
1)
Connection target
information
Shows the information of the specified PLC CPU.
2) Operation
Designates the operating state of the PLC.
The following designations are possible:
STOP, PAUSE, STEP-RUN, RUN, RESET and latch clear.
3)
Operation during
RUN,STEP-RUN
Sets the operation with respect to the device memory and signal flow in the RUN and
STEP-RUN states.
4)
Specify execution
destination
Sets the applicable station for remote operation.
• Currently specified station
Executed only at the station with the connection destination designation.
• All stations
Executed at all stations of the network designated as the presently designated station.
1 to 4 modules can be set for execution module designation.
• Specific group
Executed in a specific group of the network designated as the presently designated
station.
Set 1 to 4 modules for execution module designation and set the group number.
5)
Execute
button
Click this button after setting the necessary settings.