Filter
Top Products
GNS 530(A) Pilot’s Guide and Reference
190-00181-00 Rev. E
7-21
SECTION 7
WPT PAGES
Modifying User Waypoints
To modify an existing waypoint, select that waypoint
on the User Waypoint Page and enter the new position
information directly over the old information.
Modifying a user waypoint by changing its
latitude/longitude position:
1) With the User Waypoint Page displayed, press
the small right knob to activate the cursor.
2) Use the small and large
right knobs to enter
the name of the desired waypoint and press
the ENT Key.
3) Turn the large right knob to highlight the
position field at the bottom of the page.
4) Use the small and large
right knobs to enter
the new position coordinates (Figure 7-42)
and press the ENT Key to accept the selected
position.
Figure 7-42 Position Field Selected
5) The cursor moves to the ‘Modify?’ action field.
Press the ENT Key to modify the waypoint.
6) Press the small right knob to remove the
flashing cursor.
Modifying a user waypoint by changing
reference waypoint information:
1) With the User Waypoint Page displayed, press
the small right knob to activate the cursor.
2) Use the small and large
right knobs to enter
the name of the desired waypoint and press
the ENT Key.
3) Turn the large
right knob to highlight the first
reference waypoint (REF WPT) field, to change
the reference waypoint. Otherwise, continue
turning the large right knob to highlight
the radial (RAD) or distance (DIS) field, as
desired.
4) Use the small and large right knobs to change
the identifier (if desired) of the reference
waypoint (Figure 7-43). The reference waypoint
can be an airport, VOR, NDB, intersection or
another user waypoint. Press the
ENT Key to
accept the selected identifier.
Figure 7-43 Ref Waypoint Field Selected
5) The cursor moves to the radial (RAD) field. Use
the small and large right knobs to change the
radial from the reference waypoint, if desired.
Press the ENT Key to accept the selected
radial.