Filter
Top Products
GNS 530(A) Pilot’s Guide and Reference
190-00181-00 Rev. E
10-22
SECTION 10
AUX PAGES
4) To change the altitude buffer, turn the large
right knob to highlight the ‘Altitude Buffers’
field (Figure 10-32). Use the small and large
right knobs to enter the desired buffer
distance. Press the ENT Key when finished.
Figure 10-32 Buffer Distance Field Selected
NOTE: When an approach has been loaded into
the active flight plan, airspace alert messages
are disabled within 30nm of the destination
airport.
Setup Page: CDI Scale/Alarms
Changing the maximum CDI scale:
1) Select ‘CDI/Alarms’ from the Setup Page, using
the steps described at the beginning of this
section.
2) The flashing cursor highlights the ‘Selected CDI’
field (Figure 10-33). Turn the small right knob
to select the desired CDI scale. The selected
scale and any lower scale settings are used
during the various phases of flight as described
at the beginning of this section.
Figure 10-33 Selected CDI Field Highlighted
3) Press the ENT Key to accept the selected
scale. The ‘System CDI’ field displays the CDI
scale currently in use. The ‘System CDI’ setting
may differ from the ‘Selected CDI’ depending
upon the current phase of flight (as described
previously in this section).