Filter
Top Products
UPPER OVEN - RST Models
RC231002 Rev. 3 104
Figure 95
When replacing the glass, spread the side frame pieces
apart slightly. Carefully slide the glass into the frame being
sure the gasket stays in place and does not double over on
itself. Carefully place top frame piece in place. Be sure the
gasket is in place properly and does not fold over when
replacing the frame.
HANDLE REMOVAL - Remove the two (2) screws holding
the handle to the bottom of the door.
DOOR STRIKE REMOVAL - Remove the control panel.
Cut or push away insulation. Use a wrench to remove strike.
DOOR CATCH REMOVAL - Open oven door. Grasp top
Upper Oven Door Assemblies Removal
Remove the three (3) screws holding the top hinge to the
chassis.
EXTREME CARE SHOULD BE TAKEN TO BE SURE THE
DOOR DOES NOT DROP AND BREAK.
NOTE: The unit MUST be clear of overhead cabinets to
remove screw.
DISASSEMBLY - Pull gasket from slot in door.
When replacing gasket, be sure it is installed properly and
that it seals the door to the chassis when closed.
IMPORTANT: It is not necessary to remove the door gasket
(black) when replacing the door glass. However, caution
must be taken to be sure the gasket does not stretch or get
torn when the frame is removed or replaced.
GLASS REMOVAL - Remove door and lay face up on a
pad. Remove the two (2) screws on each side of the door
at the top. Carefully slide the top frame piece out of the door
assembly. The glass can now be lifted out of the door frame.
BE SURE THE GASKETS IN THE FRAME DO NOT COME
OUT WITH THE GLASS. IF A PIECE OF GASKET DOES
COME OUT, REPLACE IT IN THE FRAME BEFORE
REPLACING GLASS.
and bottom edges of catch with a pliers, squeeze together
and pull catch out of door.
OVEN DOOR HINGE REMOVAL - Top Hinge - Open oven
door to gain access to screws on right side of chassis. Hold
door and remove the three (3) screws (black) holding hinge
to chassis.
DO NOT ALLOW DOOR TO FALL AND BREAK. LIFT
DOOR AND HINGE STRAIGHT UP.
BOTTOM HINGE - Remove top hinge and door. Remove
three (3) screws (black) holding bottom hinge to oven
chassis.
NOTE: Door must be leveled when reinstalled. See "Door
Alignment".