Filter
Top Products
HotCup Operators’ Guide Initial Setup
November, 2007 25 6740001
e. The following figure shows a coin mechanism, bill validator, and card reader connected to
one another via an MDB. Some monetary configurations may not include all of these
devices. Connect your coin mechanism as shown:
f. Turn ON the main power switch. Select MDB mech in the SELECT COIN MECHANISM AND
OPTIONS procedure on page 2-11. Press until the standby message is displayed,
then press . Insert enough coins through the coin slot into the coin tubes to more than
cover the empty sensor. Insert coins one at a time and ensure they lay flat in the tubes. The
amount of coins you insert is internally recorded.
g. Payout about 6 coins to ensure proper loading.
h. Finish inserting coins through the coin slot to fill all the tubes with coins.
i. Visually check the coin tubes to make sure coins are not shingled.