Filter
Top Products
HotCup Operators’ Guide Testing
November, 2007 79 6740001
TEST THE BREWER
a. Press , then press until the display shows
BREW TEST.
b. Press to test each brewer position:
WARNING
Keep away from the brewer mechanism while it is operating.
Coming into contact with moving parts could injure you.
i.
BREW CLMPD The brewer is in the brew position.
ii.
BREW HOME The brewer is in the HOME position.
c. CONTINUE.
TEST VARIOUS SENSORS AND SWITCHES
a. Press , then press until the display shows
IN.XXXXXX. The X's in the
display will be replaced by the following place holders: M K P H L 1, defined as follows:
M = mug/cup sensor (if equipped) K = freevend keyswitch
P = waste pail switch H = high water tank level switch
L = low water tank level switch 1/2 = ring 1/2 cup sensor switch
b. Actuate each switch or sensor to test its function. As you actuate each input, the display
element representing that switch blinks on. Releasing the switch causes that element to blink
off again, and be replaced by a dash.
c. CONTINUE.
RINSE ALL MIXING BOWLS
WARNING
Very hot water will be dispensed in this test. Coming into contact
with hot water is dangerous!
a. Press , then press until the display shows
BOWL RINSE.
b. Press to rinse all bowls.
RINSING is displayed.
c. CONTINUE.