Filter
Top Products
HotCup Operators’ Guide Hot Drink Setup
November, 2007 51 6740001
VIEW OR SET THE HOT WATER TANK TEMPERATURE
a. Press then until the display shows
SET 202 °F . In this example, 202° is the
water tank temperature setpoint in degrees Fahrenheit. If a decimal point appears next to the
“F”, the heater is on.
b. If desired, enter a new setpoint in the accepted range of 149° - 205° F (65° - 96° C).
NOTE
The lower limit for vending is 20° below setpoint, up to a
maximum of 180° F (82° C).
c. To change display units (replace the “F” with a “C” for Celsius), press .
d. Continue.
SET UP LOW TEMPERATURE DISPENSING
a. Press then press until the screen displays either:
LTDIS off. This causes the machine to operate the same as the previous HotCup Center.
For example, with a setpoint temperature of 202º F the machine will inhibit vending when the
water tank temperature reaches 182º F.
-or-
ltdis on. Allows vending to a water tank temperature of 140º F.
b. Press to change between ON and OFF.
c. Continue.