Filter
Top Products
HotCup Operators’ Guide Messages
November, 2007 75 6740001
EDIT CUSTOM MESSAGES
a. Press , and press until the display shows
EDIT MSG'S. Press the number of
the message you want to edit.
MESSAGE X is displayed (X represents the message
number you pressed).
b. Press . The message text is displayed with the first character flashing.
c. To view the message, press . The message scrolls across the display. To stop the
scrolling, press .
d. When the character you want to change is flashing, either enter it directly, or use and
to step through the character set until the desired character is displayed. Use the
arrow keys to highlight different characters. See the section on the next page for an
explanation of special keys and the character set.
SHORTCUT
Instead of stepping through the whole character set to enter a letter that is not on your
keypad, enter one close to the one you want, then step to it. Example: If you want to
enter an L, first press J on the selection switch panel.
Then press twice. Your L should now be displayed.
THE END OF MESSAGE CHARACTER
This is the most important character in your message, because it tells the machine when the
message is ended. If you don't use this character, your message will be followed by a bunch of
zeros. This character can be selected either from the character set or by a direct key entry (see the
next page).