Filter
Top Products
Programming Procedures HotCup Operators’ Guide
6740001 38 November, 2007
Programming Procedures
SOME CONVENTIONS
The pages that follow contain all the programming procedures for the HotCup. If you need to do a
specific task, you can find it immediately by using the Programming Index. Most of the procedures
have things in common, and here is a short guide to help you through these conventional
presentations:
• All programming procedures assume that you are starting with the standby message showing
in the display. If not, just press until you get there.
• Each programming procedure is highlighted by a pointing hand: so it will stand out.
• To exit a mode (CONTINUE) at any time, press . Sometimes you may have to press
the key more than once in order to exit all the way to the standby message.
• Text that looks like this:
DISPLAY represents what you will see in the display on the
monetary panel.
• Definitions and helpful information will appear in shadow boxes:
THE SUPERVISOR MODE
The supervisor is allowed to do things that a normal user cannot, like controlling access to certain
modes. The supervisor can lock out any of the programming modes to anyone who does not have
the right "key". Once a supervisor enters the proper code, he or she will be able to:
• Change the supervisor access code
• Lock out any or all of the service keypad modes
• Select whether price lines are used
• Set whether data is cleared after being downloaded into a portable data collection device
• Grant or deny access to data items during
DATA RECALL
• Modify the machine configuration
GAIN ACCESS TO THE SUPERVISOR MODE
a. Press . The display shows:
ENTER CODE. You must enter the four-digit supervisor
code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of
0000.
b. When you have entered the right code, you will hear two beeps and see
UNLOCKED in the
display.
HELPFUL HINT