Filter
Top Products
PosiVend HotCup Operators’ Guide
6740001 66 November, 2007
VIEW MACHINE ID NUMBER
a. Press , then press or until the display shows
I.D. XXXXXX . The X’s
represent the 6-digit machine ID number.
b. You can edit the machine ID number if the supervisor access code has been previously
entered (See “Gain Access to the Supervisor Mode” on page 38).
c. Continue.
VIEW CUP RING CYCLES RELATED TO POSIVEND™
(Not shown if zero)
a. Press , then press until the display shows
PV.TOT xx. XX represents the
number of vends during which more than one ring cycle was required to successfully
dispense a cup.
b. Press to clear the count.
c. Continue.
VIEW TIMES NO CUP WAS DETECTED AFTER A CUP RING CYCLED
(Not shown if zero)
a. Press , then press until the display shows
PV.FL1 xx. XX represents the
number of times a cup was not detected after ring 1 cycled. Check the cup ring adjustment
(see the Operator’s Guide), or the cup stack for damage if the count is excessive.
b. Press to clear the count.
c. Press until the display shows
PV.FL2 xx. XX represents the number of times a cup
was not detected after ring 2 cycled. Check the cup ring adjustment (see the Operator’s
Guide), or the cup stack for damage if the count is excessive.
d. Continue.
VIEW HOME SWITCH USAGE RELATED TO POSIVEND™
(Not shown if zero)
a. Press , then press until the display shows
WO.PV xx. XX represents the
number of times home switches were used due to opt’n posi.v selected but not working.
b. Continue.