Filter
Top Products
Initial Setup HotCup Operators’ Guide
6740001 26 November, 2007
7. Fill the Tank:
a. Make sure the main power switch is ON.
b. Turn on the water at its source.
c. On the service keypad, press , then press until the display shows TANK.FILL.
d. Press . You should hear water running into the tank, and the display will show
FILLING. The water will run until either the tank is full or 12 minutes go by, whichever
happens first.
NOTE
The inlet water valve only stays open for 12 minutes at a time.
This is a safety feature to prevent water from running into a leaky
system and making a mess. It is possible for your tank to take
longer than 12 minutes to fill if your location has low water
pressure. To be on the safe side, check for leaks if the water runs
a long time. If you find none, everything is normal; you just have
low water pressure.
e. When you hear the water stop running, repeat steps 3 and 4. Under normal circumstances,
nothing will happen. If water starts running and the display shows FILLING again, your
pressure is low and it is just taking a long time to fill the tank. Repeat this step if necessary to
be sure your water tank is full.
8. Fill the Canisters:
Open the lid as shown, and carefully pour the appropriate product into the canister. Repeat for
all canisters in the machine.