Filter
Top Products
25
4 OPTION ADJUSTMENT MODE
4.1 How to Change the Setup Options (Classic, Designer & Integrated models)
4.1.1 Rinse Aid, Water Supply Hardness, Auto Power , End of Cycle Beeps, Closed Drawer Option, Clean/
Dirty Dish Symbol.
To enter this setup mode, press POWER, then hold the ECO touch switch and KEYLOCK button simultaneously
for 5 seconds, ensuring that ECO is pushed rst. Once the setup mode is entered a beep is emitted and the LCD
displays the letters rA on classic models only. Pushing the START/PAUSE button allows the user to scroll through
and change the following options:-
•RinseAidSetup(rA)
•WaterSupplyHardnessSetup(hd)–onlyavailableonwatersoftenermodels
•AutoPowerOption(AP)
•EndofCycleBeeps(EC)
•ClosedDrawerOption(Ld).
•Clean/DirtyDishSymbol(dS)
Note: there is no dry enhancement mode.
On a Designer or Integrated DishDrawer™, where there is no display, the user can still tell which option they
have chosen by using the lights showing on the integrated badge or secondary display panel as follows:-
Integrated Designer
Option Light Colour Secondary Panel Light Colour Secondary Panel
Rinse Aid
Setup
Red Light above
Start /Pause
1-5 LED’s will show set
level
Blue light above
start pause
1-5 LED’s will show set
level
Water Supply
Hardness
Green light above
start pause
1-5 LED’s
O LED’s is option o
Red light above
start pause
1-5 LED’s
O LED’s is option o
Auto Power
Option
Orange lightabove
start pause + Red
above ECO
All LED’s is option on
No LED’s is option o
Purple light above
start pause + Red
above ECO
All LED’s is option on
No LED’s is option o
End of Cycle
Beeps
Green light above
start pause + Red
above ECO
All LED’s is option on
No LED’s is option o
Blue light above
start pause + Red
above ECO
All LED’s is option on
No LED’s is option o
Closed Drawer
Option
Red light above start
pause + Red above
ECO
All LED’s is option on
No LED’s is option o
Red light above
start pause + Red
above ECO
All LED’s is option on
No LED’s is option o
Push POWER at any time to exit this setup mode.
4.1.2 Rinse Aid Setup (rA)
The current rinse aid setting is shown using the red LEDs on the touch switch panel.
The amount of rinse aid dispensed into a rinse cycle can be varied to suit the level of hardness of the local water
supply. It can be set to 1 - 5 dispensing levels.
(1 = approx 0.5mls (1/10 teaspoon) of rinse aid, 5 = approx. 2.5mls (½ teaspoon) of rinse aid.
Push KEYLOCK to advance the rinse aid setting. Once the desired setting is achieved, push POWER to exit. The
rinse aid index is stored in EE memory, so even with the power removed the rinse aid level is retained.
(Not Wireless Model)