Filter
Top Products
70
9.27 Front Chassis Trim Replacement
1. Bottom tub only - Remove the toe kick, refer section
9.4, and the bottom cowling, refer section 9.5.
2. Remove the drawer front, refer section 9.2, handle
refer section 9.3, and the tub, refer section 9.6.
3. Remove both the left hand and right hand yokes, refer
section 9.20. This is to prevent damaging the locating
tab at the front of each yoke where it slides up into the
rear of the chassis trim.
4. Remove the trim by releasing the trim clips with long
nose pliers, and pull trim forward to release from the
chassis.
5. Ret in reverse manner.
Trim Clips
9.28 Single Integrated Vent Duct Removal
(Some models only)
1. Remove the drawer front, refer section 9.2.
2. Pull the drawer front slightly forward and remove the
T10 torx screw retaining the duct.
3. Slide the duct from the right hand side o the tub.
4. Ret in reverse manner.
T10 Torx Screw
Slide O Tub
D
D
D