Filter
Top Products
59
9.4 Toe Kick Removal
1. Partially open the bottom drawer.
2. Loosen the right and left hand toe kick screws.
3. Slide the toe kick towards the front of the tub until it
comes o the mounting rails.
4. Ret in reverse manner.
Retaining
Screw
9.5 Lower Tub Cowling
1. Remove the lower drawer front (refer section 9.2)
2. Remove the toe kick (refer section 9.4)
3. Release the centre clip as shown and slide the cowling
forward.
4. Ret in reverse manner.
Clip
Cowling
9.6 Tub Removal
1. Open the drawer.
2. Removing the drawer front (refer section 9.2) makes it
easier to slide the tub rails back (optional).
3. Top tub : depress the right hand tub clip and push it
back about 30mm. Repeat for the left hand side.
4. Bottom tub: remove the toe kick (refer section 9.4) and
lower tub cowling (refer section 9.5), both optional.
5. If the cowling has not been removed, then the tub
clips need to be pushed back about 130mm so the
slide clears the cowling when the tub is lifted.
6. Lift the tub o the slides and push the runners back
into the product.
7. Releasing the wire from the centre clip on the link
assembly allows the tub to be moved further from the
chassis (optional).
8. If the tub is being turned over for servicing, rotate
it counter clockwise, remembering to remove the
baskets rst. Removing the handle will prevent it from
being damaged.
9. Ret in reverse manner.
D
D
D
Rail Clip