Filter
Top Products
58
9.2 Drawer Front
1. Open the drawer
2. Locate the drawer pins on either side of the tub.
3. If the pins cannot be accessed due to being close to
a wall, remove the tub from the slides rst (refer p59,
section 9.6).
4. Use pliers to pull on the pin and remove it from the
side of the tub.
5. Support the drawer front with your hand while doing
this to prevent it dropping onto the oor.
6. Pull the drawer front down to free it from the handle
and the top locating slots in the tub.
7. Remove the earth wire from the tab on the drawer
front. If it is an integrated or at door model, it will be
necessary to unplug the integrated badge from the
badge isolator.
8. Ret in reverse manner, ensuring the earth wire is
reconnected, drawer slides are fully forward and the
pins secure through the hooks on the front end of the
slides.
NOTE: When reinserting the pins, ensure that the dividing
web is vertical as shown.
9.3 Handle and LCD Display
1. Remove the drawer front (refer section 9.2)
2. Disconnect the LCD wire harness from the controller.
3. The handle slides onto the ange at the top of the tub.
Push the handle from the right to the left to release it.
4. The handle may now be lifted clear by pulling it
forwards.
5. The LCD display is held in place by a wedge with a
spring tab. Without lifting the tab, slide the wedge
downwards using your nger tips to release, the LCD
assembly can now be removed.
6. The wiring harness can now be unplugged from the
LCD circuit board.
7. Ret in reverse manner.
Spring Clip
to release
Slide Wedge
Downwards
Slide Handle
left to release
D
D
D
D