Filter
Top Products
34
5.2 DishDrawer Diagnostics Wireless Badge Models
The diagnostics for the wireless badge models are accessed through the USER SETUP FUNCTION, to access the
User Setup Function:
Open the tub
Press and hold the PROGRAM and START/PAUSE switches on the touch panel simultaneously for 5 seconds
(ensure PROGRAM button is pressed rst).
A beep will sound
The secondary touch panel will have between 1 - 5 LED’s on.
To enter this mode:
Enter the USER SETUP FUNCTION, refer 5.2.
Press the PROGRAM button 2 times to reach the END OF CYCLE BEEPS option.
(Eco LED is on, other program LED’s either all on, or all o).
Wait 5 seconds.
Press and hold PROGRAM and START/PAUSE button’s on the secondary touch panel simulteneously for 5
seconds ( ensure PROGRAM button is pressed rst).
The product will beep and all secondary touch panel LED’s are on.
5.2.2 Display Mode
5.2.1 Diagnostic Mode
While running the diagnostic mode, press the PROGRAM button to skip to HARDWARE OUTPUT MODE (HO),
or.
Press the START/PAUSE button to select the DISPLAY MODE.
Press the PROGRAM button to successively display (for 3 seconds each)
• Current fault code, shown from Heavy through to Rinse LED’s, with Eco LED o.
• Current fault sub code, shown from Heavy through to Rinse LED’s, with Eco LED on.
• Previous fault code, shown on Heavy through to Rinse LED’s with Eco LED o.
• Previous fault sub code, shown on Heavy through to Rinse with Eco LED on.
Press and hold START/PAUSE button for 5 seconds to exit the display mode to standby USER SETUP
FUNCTION mode.
Program Button
Start/Pause Button
Eco Indicator
Program Indicators
5.2.3 Hardware Output Mode (HO)
Press the PROGRAM button to skip to FAST CYCLE MODE (FC), or.
Press the START/PAUSE button to enter HO mode.
Press PROGRAM button to successively select each hardware output device ( refer to p30 for device table).
Press the START/PAUSE button to turn a device on or o.
Press and hold the START/PAUSE button for 5 seconds to exit HO mode and return to standby USER SETUP
FUNCTION mode.