Filter
Top Products
38
Fault Code LED Display Fault Possible Causes
E8 Normal LED Solenoid fault • Check the harness connections at each
solenoid
• Coil is open circuit
• Coil is short circuit
E9 Normal &
Rinse LED
Microcontroller fault • Badge isolator ( if present)
• Detergent diverter valve
• Check harness connections
• MFB
• Controller
EC Normal & Fast
LED’s
Communications error • Harness connections between the MFB
and controller
• MFB
• Faulty top controller
• Faulty bottom controller
U1 Heavy & Rinse
LED’s
Water Supply • Water turned o
• Insucient water supply pressure
• Blocked water softener lter (if tted)
• Spilt rinse aid casuing over foam in tub
• Incorrect detergent being used
• Motor rotor
• The machine is siphoning
• Inlet valve has failed
• Controller
U4 Heavy & Fast
LED’s
Other tub is faulting • The other tub has a fault which is
preventing operation of that tub.
• No repair is required to the tub showing a
U4.
U6 Heavy, Fast &
Delicate LED’s
Spray arm not detected • Spray arm not sitting on rotor
• Insucent water pressure
6.1.1 Sub Code Faults
Sub code faults help identify a particular fault within the main E fault code. The sub code is found by
pressing the START/PAUSE button while in the diagnostic display mode, the sub code is displayed
momentarily (3 sec) on the LCD (if tted) and on the secondary panel for integrated or at door
models.
Fault Code Sub
Code
LED
Display
Fault Possible Causes
E2 01 Rinse & Eco
LED
motor not
rotating
• Obstruction in motor rotor housing
• Rotor seized
• Hall sensor
02 Delicate &
Eco LED
motor drawing
too much
current
• Short in motor winding
• Hall sensor
03 Delicate,
Rinse & Eco
LED
Motor not
drawing
enough
current
• Open circuit winding
• harness connection
• Motor rotor incorrectly installed