Filter
Top Products
60
9.7 Drying Duct - Top Tub Only
1. Open the drawer and remove the drawer front
(refer section 9.2).
2. Use long nose pliers to gently release the plastic clips
while pulling the duct downwards.
3. Ret in reverse manner, and ensure clips locate
correctly.
Clips
9.8 Drying Fan and Flap Valve
1. Remove the drawer front (refer section 9.2).
2. With a small bladed screwdriver, carefully release the
small plastic clips holding the rinse aid indication LED
in place in the detergent dispenser and remove the
LED.
3. Release the rubber tabs securing the fan.
4. Disconnect the wire harness from the electronic
controller.
5. The drying fan will now come free.
6. Ret in reverse manner.
7.
Note: The fan housing apper can be replaced by
removing the cover and lifting the apper out the
housing.
To remove the cover, use a small screwdriver to depress
the 2 clips at the rear, and slide it forward to release.
Clips
Clips
Slide
Flapper
Rubber tab
D
D