Filter
Top Products
71
9.29 Internal Duct and Elbow Removal
(some integrated models only)
1. Remove the tub to gain access to the duct, refer
section 9.6.
2. To remove the chassis duct tube, remove the 13mm
nut to release the elbow and gently pull the tube from
the elbow duct.
3. To remove the rear duct elbow, the product will need
to be uninstalled and pulled forward from the joinery
to gain access to the elbow. To release elbow from the
chassis, squeeze the side tabs and pull outwards.
NOTE: When pulling the product forward out of the
joinery, remember to feed the service and ducting pipes
through the service holes to stop them from getting
damaged.
4. The ducting insulated hose is attached to the rear
elbow and ducted through the joinery.
NOTE: Refer to the product installation guide for more
detailed installation information.
13mm Nut
Elbow
Side Tabs
Insulated Vent Hose
Side Tab
D
D
D
D