Filter
Top Products
33
5.1.5 Temperature and Voltage Display
(Not available on integrated or at door models.)
During a wash cycle, the current water temperature or the power supply rail voltage of the controller can be
displayed on the LCD instead of the time remaining.
To enter temperature/voltage display mode, start a wash cycle as normal. Initiate a keylock by pressing and
holding the KEYLOCK button for 4 seconds.
Once in keylock mode, press and hold START/PAUSE for 8 seconds to enter temperature display mode. The
display now alternates between a
o
C symbol and the water temperature. Pressing the START/PAUSE button
again changes the display to alternate between an
o
E symbol and the power supply rail voltage of the controller.
To cancel temperature/voltage display mode, press the POWER button.
5.1.6 Show O/ Showroom Wash Mode
Only available on LCD models only
This mode initiates a shop show o display and wash operation demonstration.
With the DishDrawer™ powered up and turned on, the show o mode is entered by pressing and holding the
ECO and POWER buttons simultaneously for 5 seconds. Ensure that ECO is pressed rst.
The DishDrawer™ is now in the show o mode and cycles through all of the LED & LCD segments.
Pressing the POWER button now puts the DishDrawer™ into the showroom wash mode. Before running
this mode, the tub should be lled with water until it is almost touching the underside of the spray arm. The
showroom wash is started by pushing the START/PAUSE button whereby the following cycle is run:-
• The lid is pulled down.
• The wash motor starts and runs for 4 minutes.
• The wash motor stops.
• The lid is lifted.
• The display counts down to zero throughout this cycle.
• The DishDrawer™ turns o at the end of this cycle.
The DishDrawer™ is still in the showroom wash mode however, and it can be re-run by pushing POWER and
then START/PAUSE. Once show o/showroom wash mode has been initiated, the mains power supply must be
removed to exit out.
Playing Tunes
Once in showroom mode, holding the START/PAUSE button down for 3 seconds will start a tune playing.
Pressing the START/PAUSE button again will toggle the tune between Bach and Edvard Grieg’s “Hall of the
Mountain King”. This feature is not widely known about, may not be present in all models and may be removed
in future products.