Filter
Top Products
49
Fault Code E5 - Lid Fault
1. Check for any obstructions within the tub,
especially around the ange area where the lid
seals.
2. Check customer has not used tall utensils that
may have caused the lid to jam.
3. Check the lid system for any physical damage or
disconnection of yoke , clip or wiring.
4. Check wiring harness connections at the
component and at the controller for any signs
of water damage, corrosion or arcing. Replace if
damaged.
5. Check the resistance of each lid actuator at the
controller, only replace an actuator if it is open or
short circuit.
6. Chassis harness P205 pin pair 6 & 7, 8 & 9. Run
the lid actuators in diagnostics ( refer p30 & 31)
to ensure they move the lid in both upwards and
downwards directions. This can be down with the
tub removed or pulled slightly forward on the
rails.
7. If the fault still occurs, check the sub code fault
and, if problem persists, replace the controller.
Fault Code E5 - Sub Code 01 - Not Starting
1. Check harness connection at controller for signs of water damage, corrosion or arcing. Replace if
damaged.
2. Check actuator resistance (open or short circuit), if OK then replace controller.
Fault Code E5 - Sub Code 02 - No Current
1. Check harness connection at controller for signs of water damage, corrosion or arcing. Replace if
damaged.
2. Check actuator resistance, if open circuit, replace lid actuator.
3. If actuator OK, then replace controller.
Fault Code E5 - Sub Code 04 - Not Stalling
1. Check harness connection at controller for signs of water damage, corrosion or arcing. Replace if
damaged.
2. Replace the controller.
Yoke Clip
Lid Actuator
Harness
Lid Clips