Filter
Top Products
41
As the reveal between cabinets and the
Integrated unit decreases, the potential
exists for severe finger pinching or crushing
if a hand or fingers are placed in the
opening when the door is closing.
When 19 mm or thicker panels are used
and a reveal less than 6 mm is maintained,
the door panels may cause damage to the
Sub-Zero unit when the door is open at the
maximum 105˚ stop. You should use the
built-in 90˚ stop to prevent damage.
681 mm 681 mm
DOOR
SUB-ZERO
UNIT
DOOR
SUB-ZERO
UNIT
1372 mm
TO BACK
OF UNIT
REVEAL
REVEAL
REVEAL
*SUBTRACT PANEL WIDTH FROM CABINETRY OPENING TO DETERMINE ACTUAL WIDTH OF REVEAL
CABINETRY
OR SIDE
PANEL
CABINETRY
OR SIDE
PANEL
635 mm
635 mm
610
mm
3 mm* min 3 mm* min
19 mm
PA NE L 19 mm PA NE L
3 mm* min
DOOR
SUB-ZERO
UNIT
DOOR
SUB-ZERO
UNIT
1829 mm
TO BACK
OF UNIT
*SUBTRACT PANEL WIDTH FROM CABINETRY OPENING TO DETERMINE ACTUAL WIDTH OF REVEAL
CABINETRY
OR SIDE
PANEL
CABINETRY
OR SIDE
PANEL
910 mm 910 mm
635 mm 635 mm
REVEAL
3 mm* min
REVEAL
3 mm* min
REVEAL
3 mm* min
19 mm
PA NE L19 mm PA NE L
610 mm
914 mm
WIDE MODELS
Panel width dimen-
sions for installation
of two 914 mm wide
tall units side by
side.
Dimensions are based
on a 3 mm reveal. A
reveal of up to 6 mm
is possible, but panel
dimensions need to be
adjusted accordingly.
686 mm
WIDE MODELS
Panel width dimen-
sions for installation
of two 686 mm wide
tall units side by
side.
Dimensions are based
on a 3 mm reveal. A
reveal of up to 6 mm
is possible, but panel
dimensions need to be
adjusted accordingly.
PANEL
REQUIREMENTS
Door and drawer
panels must be a
minimum of 16 mm
thick.
The door panel
cannot exceed 18 kg
and each drawer
panel must not
exceed 5 kg for 686
mm wide units. For
914 mm wide units,
the door panel
weight limit is 24 kg
and 7 kg for each
drawer panel.