Filter
Top Products
Using the Hard Disk Drive for Secure and Proof Jobs
3-8
❖
DocuPrint NC60 System Administrator Guide
Using the Hard Disk Drive for
Secure and Proof Jobs
Secure and proof jobs that have been submitted to the
printer are stored as processed, ready-to-print files on the
Hard Disk Drive. These jobs can be printed (or deleted)
through the Password Menu where you enter the 4-digit
password for the job or jobs to be printed. Procedures for
printing or deleting these jobs are listed in Table 1.7 on
page 1-23.
The secure or proof job is placed at the top of the print
queue, and will print following completion of the
currently printing job. If more than one job is released,
jobs are placed on the print queue in the order released.
Secure or proof jobs having the same priority are printed
on a first released basis.
Creating Secure Jobs
Secure printing delays printing of a job until a password
associated with the job is entered at the printer’s Control
Panel. Entering the password at the Control Panel will
provide access to only those jobs sent with that password.
Secure jobs are normally created in PCL and PostScript by
choosing the feature in a driver. When not using a driver
with this feature, secure jobs may also be created by
preceding the job with the following PJL commands:
@PJL XSECUREJOB
@PJL XJOBPASSWORD = "number"
These commands must be immediately followed by a
standard PJL “JOB” command that includes the
“jobname.”