Filter
Top Products
Upgrading the Printer Software
4-20
❖
DocuPrint NC60 System Administrator Guide
Determining a
Successful Upgrade
If your upgrade is successful, you will receive a new start
up page. The “Software Version” on the start up page
should reflect the software level of the upgrade.
After the Upgrade
After a successful upgrade, some printer features may be
set to the factory defaults. Some of these parameters may
include settings that allow you to print to the printer.
These parameters must be reset before you will be able to
print. To accomplish this, you will need the previously
printed Configuration Sheet and Diagnostics page.
Using the directions in the section “Before You Upgrade”
(page 4-17), print out a new Configuration Sheet and
Diagnostics page.
Compare the original Configuration Sheet with the new
one. Identify the items that are different between the two
pages. Use CentreWare DP or the Control Panel (in some
cases both) to restore settings. If you require assistance
please contact your Xerox Customer Support Center.
Now compare the Printer Diagnostics pages. Look at the
section labeled Adjustments. If the Top Margin and Left
Margin numbers have changed they will need to be reset.
To do this use the procedure on page 1-104.
Other settings on the Diagnostics Page may have changed
due to print quality adjustments. This is normal and not a
result of the upgrade.
Finally, it is advisable to perform a Color Balance
procedure at this time to ensure optimum color printing.
See the section “Adjusting Density and Color Balance”
(page 4-8).