Filter
Top Products
System Menu
Chapter 1: Configuring the Printer
❖
1-41
Defaults
Sets default units. This is not changed
when a “Factory Default” is
performed.
The available values are:
Inches*
(for 110V configuration)
Millimeters (for 220V configuration)
The following defaults are affected by
changing this setting:
• System Menu>Paper Size
• PCL Menu>FormLength.
1. Press
Menu Up
or
Menu
Down
until you see:
Menus
System Menu
2. Press
Item Up
or
Item Down
until you see:
System Menu
Defaults
3. Press
Value Up
or
Value Down
until you see:
Defaults =
New Value
4. Press
Enter
. You will see:
System Menu
Defaults
5. Press
Online
. You will see:
Ready
Power Saver
Set the time the printer will remain
idle before low power mode is
activated.
The available values, in minutes, are:
180
120
90
60
30*
15
Off (never enter Power Saver mode)
1. Press
Menu Up
or
Menu
Down
until you see:
Menus
System Menu
2. Press
Item Up
or
Item Down
until you see:
System Menu
Power Saver
3. Press
Value Up
or
Value Down
until you see:
Power Saver =
New Value
4. Press
Enter
. You will see:
System Menu
Power Saver
5. Press
Online
. You will see:
Ready
Table 1.10 System Menu functions
(continued)
Menu Item and Function Keystrokes Display
Table1.10 Page7 of 7