Filter
Top Products
9
Models 345, 346, 349, 355 Safety
131122
S DO NOT allow untrained personnel to
operate this machine.
S DO NOT oper ate the freezer unless all
service panels and access doors are
restrained with screws.
S DO NOT r emove any internal operating
parts (example: freezer door, beater,
scraper blades, etc.) unless all control
switches are in the OFF position and ALL
PRESSURE IN THE FREEZING
CYLINDER HAS BEEN RELIEVED.
Failure to follow these instructions may result in
contaminated product or severe personal injury to
fingers or hands from hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
S DO NOT put objects or fingers in the door
spout. This m ay contaminate the product
and cause severe per sonal injury from blade
contact.
S USE EXTREME CAUTION when removing
the beater asssembly. The scraper blades
are very sharp.
This freezer must be placed on a level
surface. Failure to comply may result in personal injury
or equipment damage.
Access to the service area of the unit must be
restricted to per sons having knowledge and pr actical
experience with the unit, in particular as far as s afety
and hygiene are concerned.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. Please refer to the
cleaning section o f this manual for the proper
procedure to clean this unit.
This machine is designed to maintain product
temperature under 41_F(5_C). Any product being
added to this machine must be below 41_F(5_C).
Failure to follow this instruction may result in health
hazards and poor freezer performance.
CAUTION: This unit is pressurized whenin
operation. The control switch must be in the OFF
position until the unit is completely assembled. No part
should ever be removed from the machine while it is in
operation. No part should be removed until the control
switch has been turned to the OFF position and all
pressure has been relieved b y opening the draw valve.
Failuretofollow these instructions may result in severe
personal injury from hazardous moving parts or from
the i mpact o f propelled parts.
IMPORTANT: DO NOT obstruct air intake and
discharge openings: These units require 6” ( 152 mm)
minimum air space around all sides. Failure to follow
this instruction may cause poor freezer performance
and damage to the machine.
For Indoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of
70_-75_F(21_-24_C). The freezer has successfully
performed in high ambient temperatures of
104_(40_C) at reduced capacities.
DO NOT run the unit without product. Failure to follow
this instruction can result in damage to the unit.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.