Filter
Top Products
28
Models 345, 346, 349, 355Operating P rocedures
Step 6
Install the front bearing. Do not lubricate the front
bearing.
Figure 25
Step 7
Install the freezer door. Position the door on the four
studs on the front of the freezing cylinder. Firmly push
the door into place. Install the four handscrews on the
studs and finger-tighten them equally in a criss-cross
pattern to insure that the door is snug. Do not
over-tighten the handscrews.
Figure 26
Step 8
Place the o-ring into the groove of the hopper cover.
Figure 27
Install the hopper cover . Lock it into place.
Figure 28
Attach the vinyl tube to the pressure relief on the
hopper cover. P osition the open end of the vinyl tube
into the rear drip pan.
Figure 29
Repeat Steps 1 through 8 for the remaining freezing
cylinder(s).