the event of power over-subscription. Per-port power is enabled
by default. The default priority is low.
Note: Lower numbered ports have precedence over higher numbered
ports of the same priority.
Next Available Option:
■ priority < critical | high | low > -- Enable/Disable per-port power distribution(p. 265)
preempt-delay-time
■ [no] interface vlan VLAN-ID vrrp vrid < 1 to 255 > preempt-delay-time < 1 to 600 >
Usage: [no] vrrp vrid <VRID> preempt-delay-time <1-600>
Description: Enable the pre-emptive delay timer for the virtual router
instance.
[no] may be used to disable the pre-emptive delay timer.
Parameters:
o preempt-delay-time <1-600> - The number of seconds to delay.
Range: < 1 to 600 >
preempt-mode
■ [no] interface vlan VLAN-ID vrrp vrid < 1 to 255 > preempt-mode
Usage: [no] vrrp vrid <VRID> preempt-mode
Description: Enable/disable preempt mode for the virtual router instance.
The default value is 'enabled'.
preference
■ interface vlan VLAN-ID ip irdp preference
Usage: [no] ip irdp preference <no-default|<-2147483647-2147483647>>
Description: The preferability of the router as a default
router, relative to the other routers on the same
subnet. Higher values are more preferable.
Next Available Options:
■ number < -2147483647 to 2147483647 > -- The router preferability number. Higher values are
more preferable.(p. 256)
■ no-default -- Indicates that the router should never be used as a default by its neighbors.(p.
255)
primary-ip-address
■ interface vlan VLAN-ID vrrp vrid < 1 to 255 > primary-ip-address
Usage: [no] vrrp vrid <VRID> primary-ip-address <IP-ADDR | lowest>
Description: Specify IP address the virtual router instance will use as
a source in VRRP advertisement messages. If not set (i.e. is
264© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
