reachable-time
■ [no] interface vlan VLAN-ID ipv6 nd reachable-time
Usage: [no] ipv6 nd reachable-time <milliseconds>
Description: Congures the length of time neighbors are considered
reachable after being conrmed as reachable via the
neighbor unreachability detection algorithm. This value
appears in router advertisements sent on this interface and
is also used to manage the neighbor table entries on this node.
Next Available Option:
■ number < 1000 to 3600000 > -- Configures the router lifetime sent in router advertisements(p.
256)
receive
■ interface vlan VLAN-ID ip rip receive < V1-only | V2-only | V1-or-V2 | ... >
Dene RIP version for incoming packets.
Supported Values:
■ V1-only -- Accept RIP version 1 updates only.
■ V2-only -- Accept RIP version 2 updates only.
■ V1-or-V2 -- Accept both RIP 1 and RIP 2 updates.
■ disabled -- Do not accept RIP updates.
■ interface vlan VLAN-ID ip rip IP-ADDR receive < V1-only | V2-only | V1-or-V2 | ... >
Dene RIP version for incoming packets.
Supported Values:
■ V1-only -- Accept RIP version 1 updates only.
■ V2-only -- Accept RIP version 2 updates only.
■ V1-or-V2 -- Accept both RIP 1 and RIP 2 updates.
■ disabled -- Do not accept RIP updates.
■ interface vlan VLAN-ID ip rip all receive < V1-only | V2-only | V1-or-V2 | ... >
Dene RIP version for incoming packets.
Supported Values:
■ V1-only -- Accept RIP version 1 updates only.
■ V2-only -- Accept RIP version 2 updates only.
■ V1-or-V2 -- Accept both RIP 1 and RIP 2 updates.
■ disabled -- Do not accept RIP updates.
retransmit-interval
■ interface vlan VLAN-ID ip ospf retransmit-interval < 1 to 3600 >
Set retransmit interval in seconds; the default is 5.
Range: < 1 to 3600 >
■ interface vlan VLAN-ID ip ospf IP-ADDR retransmit-interval < 1 to 3600 >
Set retransmit interval in seconds; the default is 5.
Range: < 1 to 3600 >
273© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
