Filter
Top Products
SGB Batch Blender with Mitsubishi Controller Page 105 of 118
12 Appendix
Important! Hidden, programmable features and hidden menu pages should
not be made available to floor operators. These pages include the
Service Supervisor Information addendum located in this section.
Unauthorized changes to these factory settings by inexperienced
operators may prevent the SGB unit from operating properly, and
may void part or all of the warranty.
12-1 Addendum Service Supervisor Information
Note: Should not be used by untrained personnel – blender
controller and/or program can be compromised!
12-1-1 Programmable Settings
SGB
The SGB Series blender software program has been designed to allow
some customizing to achieve certain desired operating parameters.
The following is a listing of the selections that are “field”
programmable, followed by the procedure for doing so.
This menu is accessed by pressing the Sterling icon when in the
“Setup” Directory Screen menu.
You must have logged in on the Inventory Page using the long
password 3145348 to gain access to the “Sterling Engineering Only”
screen. The screen similar to that shown below should be displayed
and use the keystrokes described herein to change or toggle the
parameters.
Touch this icon and
enter in the Service
Password to access
the Sterling
Engineering Only
Directory
Go back to
Setup
Directory