Filter
Top Products
Page 78 of 118 SGB Batch Blender with Mitsubishi Controller
Maintenance 6
6-1 Work Rules
The installation, operation, and maintenance of this equipment must follow all
applicable work and safety codes for the location where it is used. This may
include, but is not limited to, OSHA, CSA, NEC, SPI, and other local, national,
and international regulations. In addition, you must observe the following
specific rules:
; Read and follow these instructions when installing, operating, and
maintaining your equipment. If the instructions become damaged or
unreadable, you can obtain additional copies from the Service
Department at Sterling.
; Only qualified people may work on or with this equipment.
; Work only with approved tools and devices.
; Turn off and lock out the power switch when maintaining or servicing
your blender system.
; Disconnect and lock out main power before servicing electrical
equipment.
6-2 Maintaining Blenders
Sterling blenders need periodic maintenance to provide long dependable
service. Check these elements regularly:
• Check functionality of safety circuit daily.
• Maintain proper air pressure and drain water from trap assembly on
regulator – as required.
• Periodically lubricate slide gate rails.
WARNING!
Always remove plug and disconnect power before servicing
blender.
Always read operating manual before operating or servicing
blender.