Filter
Top Products
Page 28 of 118 SGB Batch Blender with Mitsubishi Controller
before starting the unit.
• At the beginning of your shift and after breaks, verify that the controls
and other auxiliary equipment are functioning properly.
• Keep all safety guards in place and in good repair. NEVER attempt to
bypass, modify, or remove safety guards. Such alteration is not only
unsafe, but will void the warranty on your equipment.
• When changing control settings to perform a different mode of operation,
be sure selector switches are correctly positioned. Locking selector
switches should only be adjusted by authorized personnel and the keys
removed after setting.
• Report the following occurrences IMMEDIATELY:
• unsafe operation or condition
• unusual blender action
• leakage
• improper maintenance
• NEVER stand or sit where you could slip or stumble into the blender
while working on it.
• DO NOT wear loose clothing or jewelry, which can be caught while
working on a blender. In addition, cover or tie back long hair.
• Clean the blender and surrounding area DAILY, and inspect the
machine for loose, missing or broken parts.
• Shut off power to the blender when it is not in use. Turn the switch to
the OFF position, or unplug it from the power source.
2-7 Maintenance Responsibility
Safety is essential to the good health of both operator and machine. If you are a
maintenance worker, you must make safety a priority in order to effectively repair
and maintain equipment.
BEFORE REMOVING, ADJUSTING, OR REPLACING PARTS ON A MACHINE,
REMEMBER TO DO THE FOLLOWING:
• BLEED all air pressure from system components (refer to the Maintenance
Section of this manual.)
• TURN OFF all air and electric supplies and all accessory equipment at the
machine.
• DISCONNECT AND LOCK OUT electrical and pneumatic power, and attach
warning tags to the disconnect switch and air shutoff valve.