Filter
Top Products
Page 68 of 118 SGB Batch Blender with Mitsubishi Controller
This display indicates the amount of material in pounds that has been
used by each feeder of the recipe. It is important to note that the
weights are rounded off to the closest pound. On minor ingredients,
several cycles may have to occur to show an inventory number.
In addition to showing the amount of material that has been used for
each feeder, this screen is also a summary display that shows the total
inventory, the time for the last batch, and the average rate of the
blender.
If the blender is run in “Percentage Mode” instead of “Quick Set” during
operation, the “Percentage Mode” will use the blender inventory
numbers shown on the Inventory screen to calculate the percentages
for each ingredient. It is important to zero the inventories when a recipe
is changed to have this screen accurately reflect the current
percentages of the recipe in-process.
Note: Blender inventories must be cleared when the current recipe is
started to show accurate percentages for the current recipe.
To clear inventories, press the “Clear Inventory” key on the
“Inventory” screen.
5-8-14 Recipe Menu
Note: Refer to the menu structure in section 5-4 for more information.
The SGB System contains several operator friendly recipe menus. This
section of the manual lists these recipe menus:
• Recipe Page (Start/Setup)
Inventory
T
o
tal
s
Go to Recipe
Page
Average
Bat
c
h Tim
e
Blender
Maximum Rate
Clear the
inventory
totals
Accumulated
N
umber of Batches
Material
Usa
g
e Rate